Kenmore washer tub very loose - Appliance Repair Forum - Free Service from Appliance Parts Pros

Welcome Guest! You can not login or register.

Notification

Error

Kenmore washer tub very loose Options Email this topic Watch this topic Print this topic » Normal Threaded
Model: 110 82673810	Brand: Kenmore	Age: More than 10 years
Previous Topic Next Topic

ron-e-g		#1 Posted : Wednesday, March 10, 2010 5:51:01 PM(UTC)
Rank: Member Groups: Registered Joined: 3/10/2010(UTC) Posts: 3		Can someone help with a parts sheet or give me some advise as to how I would diagonose and repair this loose tub? I suspect the dampers but I can't figure out how to even get the top off to look!:) Thanks in advance. Ron


User Profile View All Posts by User View Thanks

Sponsor

See inside of your appliance - diagrams and part photos for virtually every model.

sidfink43		#2 Posted : Friday, March 12, 2010 3:08:50 PM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 3/29/2009(UTC) Posts: 11,699		This site will show you how to take off the cabinet to inspect it. Check the springs and the support plate. Kenmore top loader blues (SublimeMasterJW's Appliance Advice)


User Profile View All Posts by User View Thanks

ron-e-g		#3 Posted : Saturday, March 13, 2010 8:17:09 AM(UTC)
Rank: Member Groups: Registered Joined: 3/10/2010(UTC) Posts: 3		Originally Posted by: sidfink43 This site will show you how to take off the cabinet to inspect it. Check the springs and the support plate. Kenmore top loader blues (SublimeMasterJW's Appliance Advice) Thanks sidfink. I have already removed the cabinet. All the springs are attached. I don't know what to look for other than that. As for the support plate.. same thing applies I don't know what I'm looking for. The whole unit ( motor, pump and plate seems to move very freely) I don't know how it all should feel normaly.:( Also I removed the drive block and inspected it.... it seems OK but yet again what's OK?:D


User Profile View All Posts by User View Thanks

sidfink43		#4 Posted : Saturday, March 13, 2010 3:04:41 PM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 3/29/2009(UTC) Posts: 11,699		Look at the pads on the plate, but even if they are worn and need replacing I would also replace the springs. It is an easy and inexpensive process. Many times they are bad, but it is not noticeable to the ********** eye.


User Profile View All Posts by User View Thanks

ron-e-g		#5 Posted : Wednesday, March 17, 2010 12:05:33 PM(UTC)
Rank: Member Groups: Registered Joined: 3/10/2010(UTC) Posts: 3		Thanks sidfink.


User Profile View All Posts by User View Thanks

Users browsing this topic
Guest (3)

Forum Jump

You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Important Information: The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies. More Details Close