Rank: Member
Groups: Registered
Joined: 3/10/2020(UTC) Posts: 0
|
My 2013 Whirlpool Duet front load washer is displaying these codes: F06 E01
Repair guy came out today, didn't even look at the washer. Just looked at the codes I wrote down and said I needed to replace the two boards (MCU and CCU). He left. I tore it apart. Looked at all connections and everything was plugged in correctly and secure.
Washer front panel display works, senses, door locks, but the drum doesn't move.
What would you recommend doing next? Buying both boards? I'm comfortable changing them. But they're expensive to buy if that's not the problem.
Can those codes indicate any other problems?
|
|
|
|
Rank: Member
Groups: Registered
Joined: 2/19/2020(UTC) Posts: 0 Location: New york
|
F06 indicates main control board and/or program faults.E01 Pump issue or dirty drain filter. Clean drain filter and if error code still comes up then the pump should be checked to see if it has a stuck impeller or is faulty, clogged, or the wiring harness to it is damaged or loose.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close