Rank: Member
Groups: Registered
Joined: 8/12/2014(UTC) Posts: 1
|
One circuit breaker gets hot, both CBR open after dryer w/heat runs ~10 min. Dryer will run on no heat cycle. Have not opened cabinet.
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 2/29/2008(UTC) Posts: 19,638
Thanks: 1 times Was thanked: 11 time(s) in 11 post(s)
|
Here are your parts Parts for Whirlpool WED5800SG0 Dryer - AppliancePartsPros.com See the attachment for the wiring diagram. Could be that you have a grounded element. Unplug the unit and both wires from the heater element. Measure the element, should be around 8 to 12 ohms. Then measure from each element connector to the case, both should be infinite ohms. If not the element is grounded and should be replaced. |
THIS FORUM IS DEAD!!!!!!! |
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close