Customer Support 7 days a week

Welcome Guest! You can not login or register.

Notification

Icon
Error

Options
Go to last post Go to first unread
Tom R  
#1 Posted : Tuesday, December 18, 2007 1:50:55 PM(UTC)
Tom R

Rank: Member

Groups: Registered
Joined: 12/18/2007(UTC)
Posts: 1

We have a large capacity automatic washer. It has been a great appliance. The cycle control knob is designed to be pulled outward to activate the cycles. When it gets to the spin cycle it will not spin unless you hold the knob out even further (manually). It spins fine when held out. It also sparks when you turn it off during the spin cycle.

I suspect the switch behind the knob. Can I replace the knob/switch unit only? Does it sound like I am on the right track? It is about 25 years old. Will that make a difference?

Bad time of year to be spending money on a new washer.

Thanks in advance for any assistance provided.

Tom R
Sponsor
See inside of your appliance - diagrams and part photos for virtually every model.

powered by AppliancePartsPros.com
 
Gene  
#2 Posted : Tuesday, December 18, 2007 2:06:36 PM(UTC)
Gene

Rank: Advanced Member

Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455

Was thanked: 4 time(s) in 4 post(s)
Hello Tom

Most likely the timer (the part you called "the cycle control") is bad and has to be replaced (#40 on the top and console break down diagram).

- The part number for the timer is AP2915525

- Here are the break down diagrams for the Whirlpool washer Model LA5500XMW0

Good luck.
Gene.
Users browsing this topic
Guest (3)
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.