Can not open lid - Appliance Repair Forum - Free Service from Appliance Parts Pros

Welcome Guest! You can not login or register.

Notification

Error

Can not open lid Options Email this topic Watch this topic Print this topic » Normal Threaded
Model: 110.22442100	Brand: Kenmore	Age: 5 - 10 years
Previous Topic Next Topic

Poppytrucker		#1 Posted : Saturday, May 23, 2009 6:02:57 AM(UTC)
Rank: Member Groups: Registered Joined: 5/23/2009(UTC) Posts: 1		Unit will not spin and remove water from drum. Lid switch appears to be broken. Part of switch hanging down. Can not figure out how to open top of washer to get to switch.


User Profile View All Posts by User View Thanks

Sponsor

See inside of your appliance - diagrams and part photos for virtually every model.

Qapla		#2 Posted : Saturday, May 23, 2009 1:16:25 PM(UTC)
Rank: Member Groups: Registered Joined: 5/17/2009(UTC) Posts: 17		This sounds like a top loading clothes washer? Many of these units have spring type clips that hold the top in place (it looks kind of like the spade on a playing card when you get it uncovered). They are usually reached from the front of the washer a few inches in from each corner. Try sliding a putty knife into the space between the top and the front. When you locate the fastener, locate the putty knife centered in the sprint loaded fastener. Push in on the putty knife while lifting on the front of the top. It should lift up is you are pressing the spring properly. The top should then lift like it is on a hinge. Some models have screws on the back of the head piece where it connects to the back of the body before it will hinge. Check yours. Some have short or fastened wire harness, be careful as you lift the top. To put the top back, position the washer top on top of the spring clip and press down firmly (or hit the top with your hand) and it should snap back in place Hope this helps


User Profile View All Posts by User View Thanks

Gene		#3 Posted : Saturday, May 23, 2009 5:16:42 PM(UTC)
Rank: Advanced Member Groups: Senior Expert, Administrators Joined: 7/19/2007(UTC) Posts: 27,455 Was thanked: 4 time(s) in 4 post(s)		You have to remove the washer cabinet. The instructions are attached to the replay. - The part number for the lid switch is AP3100001 Gene. File Attachment(s): How to remove the washer cabinet.doc (25kb) downloaded 3 time(s).


User Profile View All Posts by User View Thanks

Users browsing this topic
Guest (2)

Forum Jump

You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Important Information: The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies. More Details Close