Customer Support 7 days a week

Welcome Guest! You can not login or register.

Notification

Icon
Error
Kenmore HE3 won't start
Options
Go to last post Go to first unread
Model: 110.42822200 Brand: Kenmore Age: 1 - 5 years
Previous Topic Next Topic
engine207  
#1 Posted : Monday, January 19, 2009 8:31:25 AM(UTC)
engine207

Rank: Member

Groups: Registered
Joined: 9/17/2008(UTC)
Posts: 7
I'm having a problem with my washer not being able to start up. When I press one of the wash cycles, the corresponding light indicator flashes, rather than remains solid. Once it's solid, I can normally press start and get the clothes going.

I checked the striker on the door and it is not damaged, so I'm assuming that it is the receiver that is mounted inside the cabinet and protrudes through a small 1" square hole.

I found a local parts shop that stocks it, but I am not sure how to open the unit to get at it. I see a few torx screws that seem to hold it in place from the inside, but I need help finding the way to access it.

Also, if anyone suspects that it is something other than that part, I'd appreciate your thoughts. Thanks...207
Back to top
Sponsor
See inside of your appliance - diagrams and part photos for virtually every model.

powered by AppliancePartsPros.com 		 
Back to top  
Drags1998  
#2 Posted : Monday, January 19, 2009 1:48:31 PM(UTC)
Drags1998

Rank: Advanced Member

Groups: Senior Expert
Joined: 9/7/2008(UTC)
Posts: 750
The way to get to the door switch is to remove the OUTER boot clamp, There should be a spring at the bottom of the opening, carefully remove the wire and spring. The switch is just inside of the opening!!:)
Back to top
midnitemill  
#3 Posted : Monday, January 19, 2009 4:13:31 PM(UTC)
midnitemill

Rank: Member

Groups: Registered
Joined: 1/16/2009(UTC)
Posts: 7
I had the same problem. I broke the locking clip inside small hole so I had
to pull the door lock. Don't know if this is my problem but I need to replace
it now. If you get any info please post and good luck
Back to top
midnitemill  
#4 Posted : Wednesday, January 21, 2009 6:17:06 PM(UTC)
midnitemill

Rank: Member

Groups: Registered
Joined: 1/16/2009(UTC)
Posts: 7
Got new door switch installed ran diagnostic test all is good
Cycle still won't start found out my delicate cycle botton won't
turn on cycle.
Back to top
richappy  
#5 Posted : Thursday, January 22, 2009 1:32:30 AM(UTC)
richappy

Rank: Advanced Member

Groups: Senior Expert
Joined: 9/10/2007(UTC)
Posts: 9,586

Was thanked: 2 time(s) in 2 post(s)
If you have a meter, you could pull off the top cover and check the door switch at the control board.
Back to top
Users browsing this topic
Guest (3)
Similar Topics
Kenmore HE3 won't start, with no codes? (Washer Repair)
by ZEUS1981 2/4/2010 5:00:39 PM(UTC)
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Privacy Policy | Powered by YAF.NET | YAF.NET © 2003-2024, Yet Another Forum.NET