Your element checks OK (resistance is in range) so you're correct about that.

However, there is a thermal fuse(thermostat) that also has to be a closed circuit (infinite resistance). it is located on the bottom of the tub(looks like a little white box).

You may want to trace the orange wire at the heater terminal back to the thermal fuse.

And then,

There's the 3 button selector switch on the control panel.

When you select heated dry the switch contacts should close(infinite resistance) between red and white w/ red stripe.

When you select normal / air dry the circuit should open.

If those all check OK, the last possibility would be a bad heater circuit in the timer or a broken wire in the harness between any of those 3 components.

Good luck,

:) :) :)

OK, not a problem,

That's what we're here for.

Hope you don't need a timer, but it,s a possibility.

:cool: :cool: :cool: