Rank: Member
Groups: Registered
Joined: 1/29/2013(UTC) Posts: 2
|
My oven will not longer heat - the burners, warmer, clock panel, convection turns on.
I changed the electronic contol panel and it still isn't working.
Can you please help me with reset button, is it a sensor, or wiring?
Kenmore Elite Dual Fuel Range Model 790 7938 p/n 316417312
Pam
|
|
|
|
Rank: Advanced Member
Groups: APP Team
Joined: 2/12/2012(UTC) Posts: 5,556
|
Hi.
There is no any fuses or hi-limit thermostats in your range. Check if there is 240VAC to the connector block. Check the wiring harness to the elements and control board.
Simon.
PS. The model number you provided is not complete.
|
|
|
|
Rank: Member
Groups: Registered
Joined: 1/29/2013(UTC) Posts: 2
|
Simon,
Do i have fuses? Where is the connector block? Is the wiring i need to check by the control board?
MODEL 79079383401
do u think its my wiring? where is the sensor?
Pam
|
|
|
|
Rank: Advanced Member
Groups: APP Team
Joined: 2/12/2012(UTC) Posts: 5,556
|
Hi, Pam.
I meant that there is no fuse inside your range. You need to check at the wall outlet if there is 240VAC. You need to use the multimeter for that. Remove the rear panel to check the wires going to the elements. What did you replace? Was it the control board/clock or the control panel. If you didn't replace the control board, then most likely it 's the problem unless there is no proper voltage to the unit.
Simon.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close