Rank: Member
Groups: Registered
Joined: 1/9/2010(UTC) Posts: 4
|
Replaced heating element but cannot clear the flashing clean light.
|
|
|
|
Rank: Member
Groups: Registered
Joined: 1/9/2010(UTC) Posts: 4
|
Originally Posted by: tjl1954 Replaced heating element on my Whirlpool Dishwasher Model No. DU1055XTPQ4 but cannot clear the flashing clean light.Is there a code?]
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 2/29/2008(UTC) Posts: 19,638
Thanks: 1 times Was thanked: 11 time(s) in 11 post(s)
|
|
THIS FORUM IS DEAD!!!!!!! |
|
|
|
Rank: Member
Groups: Registered
Joined: 1/9/2010(UTC) Posts: 4
|
To Denman, I tried your solution to my problem and it did not work.Is there a sequence that I should be using?
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 2/29/2008(UTC) Posts: 19,638
Thanks: 1 times Was thanked: 11 time(s) in 11 post(s)
|
As far as I know you just follow the sequence i the data sheet.
You cold try removing power from the unit for half an hour or so to see if that may reset it.
If that does not work then perhaps the board is blown, Did you check the original heater with a meter before replacing it? Did you check the hi-limit thermostat? |
THIS FORUM IS DEAD!!!!!!! |
|
|
|
Rank: Member
Groups: Registered
Joined: 1/9/2010(UTC) Posts: 4
|
Thank You denman,I was not following the right sequence.The dishwasher is operating.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close