Rank: Member
Groups: Registered
Joined: 7/5/2023(UTC) Posts: 0 Location: Ohio
|
I have a Maytag model MVWC565FW1 top load washer. During the rinse fill cycle, the washer will start to fill for about two minutes, then sit for about 4 minutes, then fill for about two minutes again, then sit for about 4 minutes. This process continues until the washer is full and then the rinse cycle will proceed. I have checked the water inlet screens. Also, the flow rates for the hot and cold water appear to be about the same. The washer is about 5 years old and was working just fine up until a few weeks ago. Any insight would be greatly appreciated!
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close