Rank: Member
Groups: Registered
Joined: 2/6/2008(UTC) Posts: 3
|
Here is my problem I have the hotpoint that dries for a couple of loads then does not dry -- see old thread on subject I replaced the coils - checked for continuety - and still have the same problem - heats fine for 3-4 loads then load 5 is damp then no heat It just did it - worked fine on sensi dry for 3 loads-then would not ignite on load 4- switched to timed dry and it ignited but must of gone out as the clothes did not dry. I need an idea - ??timer switch
Mike
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators Joined: 7/19/2007(UTC) Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
Hi Mike, It should be the hi limit thermostat (#530 on the drum and duct break down diagram). - The part number for the hi limit thermostat is AP2042686 To make sure this is the beast- you have to check it for continuity right at the time when the dryer stopped heating. Here are the break down diagrams for the GE dryer Model DLL2450RALGene.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close