Rank: Member
Groups: Registered
Joined: 9/19/2012(UTC)
Posts: 1
|
changing compressor relay and using hard start kit from supco model rc410
need wiring diagram to install kit as i forgot which wires went to overload and which went to relay
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
This kit comes with the installation instructions. It has 2 wires for the incoming power connection and it does not matter which wire where goes. - Start booster Part number: RC0410
Gene.
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 9/10/2007(UTC)
Posts: 9,586
Was thanked: 2 time(s) in 2 post(s)
|
I would not use a 3 n 1 hard start device on any domestic refrigerator. Will not provide good thermal and overload protection and may burn out the compressor without warning during these conditions.They have been known to cause house fires if the compressor has burnt windings.
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
