Rank: Member
Groups: Registered
Joined: 9/18/2012(UTC) Posts: 2
|
my g.e. profile dishwasher is not completely pumping out, every other time. i cleaned the sump out, there was no debris in it. any suggestions on what i should check next?
thanks, richard
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 2/29/2008(UTC) Posts: 19,638
Thanks: 1 times Was thanked: 11 time(s) in 11 post(s)
|
Here are your parts Replacement parts for General Electric GSDL132F01WW Dishwasher | AppliancePartsPros.comI would check the drain hose, especially where it attaches to the house plumbing. Next would be the piston and nut (Item 564 in Section 1). It is behind/under the screen filter at the back of the tub. It unscrews. If it does not seal correctly then during the drain cycle some of the water gets back into the tub instead of out the drain. |
THIS FORUM IS DEAD!!!!!!! |
|
|
|
Rank: Member
Groups: Registered
Joined: 9/18/2012(UTC) Posts: 2
|
thank you for your reply. the piston nut looks like my problem, the seal is deteriated. you were very helpfull in knowing where to look for it. thank again, richard
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close