Rank: Member
Groups: Registered
Joined: 12/4/2016(UTC)
Posts: 2
|
I went step by step with the tech sheet. Did the fault history and then allowed it to go into diagnostic mode. All that happened was the clean washer light kept flashing. No sounds or motion from any component. Unpluged the unit, waited 2 minutes and tried it again. No luck. Bypassing the fault history step and going to manual diagnostics was no help. Pressing 2nd rinse only changed screen from 25 to 15. Never into diagnostic mode.
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
Unplug the washer. Check all wires and connections between the User Interface board and CCU. Unplug them and plug back. Restore the power to the washer and give it try. If the problem still exists, you would need to replace the CCU and, probably, the UI board. If it would not fix the problem and you ordered parts from AppliancePartsPros.com, you can easy return them. The CCU Part number: AP6022621
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
