Rank: Member
Groups: Registered
Joined: 9/7/2009(UTC) Posts: 2
|
washer seems to start to run as soon as you lock the door, the normal cycle light is now on and stays on and you cannot select any other cycle. (seems to be locked up?) motor is running but no water flows at all. it does this continuously until i open the door or turn off power. any suggestions, please!!
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators Joined: 7/19/2007(UTC) Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
Sounds like the problem is a bad sequence switch (#904 on the diagram), but there is a small chance for the control board to be bad as well. - The sequence switch Part number: AP2616983
|
|
|
|
Rank: Member
Groups: Registered
Joined: 9/7/2009(UTC) Posts: 2
|
Is there any way to troubleshoot the bad sequence switch (#904 on the diagram) or the control board to rule either one of them in/out? Thanks for taking the time to help me.
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators Joined: 7/19/2007(UTC) Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
Remove the toe panel and look for the envelope with the tech sheet under the dishwasher tub on the right side.
Gene.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close