Rank: Member
Groups: Registered
Joined: 8/17/2009(UTC) Posts: 2
|
My Whirlpool washer fills up and goes through the wash cycle and then stops completly. It wont drain or anything after the wash cycle. Put a new timmer switch in it and still does same thing. Is there a relay or soliniod some where that might be bad?
|
|
|
|
Rank: Member
Groups: Registered
Joined: 8/17/2009(UTC) Posts: 2
|
Found my problem! The lid switch mounting tabs were broken, switch it self works but the tabs were not holding it up tite to the top. So when the lid was closed the whole switch would move and not make contact. LOL
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close