Kitchenaid range f3 and f2 error codes - Appliance Repair Forum

Welcome Guest! You can not login or register.

Notification

Error

Kitchenaid range f3 and f2 error codes Options Email this topic Watch this topic Print this topic » Normal Threaded
Model: KEDT105VBL2	Brand: Kitchen Aid	Age: More than 10 years
Previous Topic Next Topic

shane1		#1 Posted : Tuesday, May 24, 2011 6:44:04 PM(UTC)
Rank: Member Groups: Registered Joined: 5/24/2011(UTC) Posts: 1		I have an old (and I mean 22 years old) kitchenaid range model kedt105bl2. Recently it gave me a F3 and and F2 error code while preheating. One time it even turned bake off completely. We replaced the oven sensor but it is still doing the same thing. Sometimes it will work but mostly it just gives the same two error codes. I am worried it is the control panel. We are just trying to decide whether to go on and replace the oven or to try and fix it. I would be thankful for any advise you can give.


User Profile View All Posts by User View Thanks

Sponsor

See inside of your appliance - diagrams and part photos for virtually every model.

denman		#2 Posted : Wednesday, May 25, 2011 2:59:07 AM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 2/29/2008(UTC) Posts: 19,638 Thanks: 1 times Was thanked: 11 time(s) in 11 post(s)		Here are your parts Replacement parts for WHIRLPOOL KEDT105VBL2 \| AppliancePartsPros.com Yes the next logical replacement would be the control board. Looks like it is obsolete so your only option may be to have it repaired. There are companies out there that specialize in this, just Google "appliance timer repair" It may well be time to replace the unit. You could try cleaning the contacts on the control board, see below. Also check the connector on the board for a bad solder connection. Often it will be a duller gray or may have pin holes. If you wiggle the connector you may be able to see the connector move in the solder. A magnifying glass help here. Connector Cleaning / Checking Unplug the unit Open it up Clean the connector. Check the tracks for hairline cracks. A magnifying glass helps here. Would not hurt to clean the connector on the board. Use electronics contact cleaner or isopropyl alcohol and a tooth brush. Be gentle and do not reconnect till all the solvent evaporates. Reconnect everything and give it a try.
		THIS FORUM IS DEAD!!!!!!!


User Profile View All Posts by User View Thanks

Users browsing this topic
Guest (3)

Forum Jump

You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Important Information: The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies. More Details Close