Rank: Member
Groups: Registered
Joined: 4/7/2011(UTC)
Posts: 2
|
Washer jumps during the spin cycle as if there is an unbalanced load, I have read that this could be a Snubber issue, however, I observed that the tub does not stay "locked" in during agitate cycle and leans towards the back of the washer. If I simply lean on the agitator when the washer is empy, it seems to "release", is this a bad lower bearing? Most of the trouble occurs with towels or heavy loads.
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
According to the Maytag Service bulletin (attached to the post) the correction is to install the base kit specially designed to fix any balance problems. - The base kit Part number: AP4009638
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 4/7/2011(UTC)
Posts: 2
|
Thanks for the info Gene, it was very helpful. Do you have other documentation for the installation of this "Kit? Does the machine need full disassembly to install the new base? Thanks again for your time and effort.
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 9/10/2007(UTC)
Posts: 9,586
Was thanked: 2 time(s) in 2 post(s)
|
Usually, it is not necessary to replace the bottom plate.
Go to my article in the search box above "Maytag Performa washer snubber replacement" When you remove the tranny, inspect the base plate, if pitted, you will need a new one but this is rather rare.
Use vice grips to stretch and release springs and you will not need new screws for the brake housing screws.
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
