Rank: Member
Groups: Registered
Joined: 3/21/2014(UTC)
Posts: 3
|
original overload/start relay has 4 wire hookup replacement p/n w10189190 only has 2 wire hookup. part came with no instructions................how is it hooked up?
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 9/10/2007(UTC)
Posts: 9,586
Was thanked: 2 time(s) in 2 post(s)
|
The original parts where a klaxon overload and a black ptc starter.
Remove these items and install the new device.
you have no run capacitor, so the extra wires go to the condensing fan motor.
The two power wires from the fridg go to the new start device, the other two probably go to the condensing fan motor.
You will probably have to splice these to the two fridg power wires to get the fan motor running.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 3/21/2014(UTC)
Posts: 3
|
Thanks for the help.........BUT.......I'm looking for a concrete (100%) correct answer to my wiring question.....NOT a these wires PROBABLY go to ..... I want to know exactly were they go................ Thanks
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 9/10/2007(UTC)
Posts: 9,586
Was thanked: 2 time(s) in 2 post(s)
|
If you have a boxed device with overload and klaxon, it's impossible to blow out your compressor.
Specific wiring info I can't give without seeing your fridg.
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
