Rank: Member
Groups: Registered
Joined: 11/11/2012(UTC)
Posts: 3
|
Hello: I replaced surface igniter because it was arcing inside the porcelan insulator (visible looking in above). The new electrode part #8523793 is arcing underneath from the connector terminal to the collar on the igniter. This can be seen from the front with the knob cover removed. How do I prevent this? Anyone got any ideas on this on? Thnks in advance,----Mgfny
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 11/11/2012(UTC)
Posts: 3
|
From Mgfny: I experimented by using JB-Weld as an insulator. I carefully applied a generous amount all around the connector end, but not on the connector itself. I applied it all the way up to the underside of the igniter collar. It worked perfect! No more arcing and burners ignite instantly!
I used the slow-dry JB-Weld and not the quick-dry. Long term I'm not sure if JB can take heat. The specs say it will withstand 600F.
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
