Customer Support 7 days a week

Welcome Guest! You can not login or register.

Notification

Icon
Error
Burner will not stay lit
Options
Go to last post Go to first unread
Model: MGDB800VQO Brand: Maytag Age: 1 - 5 years
Previous Topic Next Topic
rlsundman  
#1 Posted : Friday, March 16, 2012 1:11:56 PM(UTC)
rlsundman

Rank: Member

Groups: Registered
Joined: 3/16/2012(UTC)
Posts: 3
Question
having problems with the burner remaining lit for more than 10 -15 Seconds.

Have purchased and changed the complete burner but still have initial start up problem - igniter glows, initial firing of the burner with a good strong blue flame. 10 - 15 seconds the gas valve closes and flame out. Allow to set 2-3 minutes and restart with the same results. I would guess Flame sensor or thermo limiters may be the cause. Any thoughts are appreciated.
Back to top
Sponsor
See inside of your appliance - diagrams and part photos for virtually every model.

powered by AppliancePartsPros.com 		 
Back to top  
Simon / APP Team  
#2 Posted : Friday, March 16, 2012 1:57:39 PM(UTC)
Simon / APP Team

Rank: Advanced Member

Groups: APP Team
Joined: 2/12/2012(UTC)
Posts: 5,556
Hello.

First we need to determine if the problem within the dryer or not.
Disconnect the vent from the dryer and run it with normal load.
If it dries OK- problem with the vent.

Very short gas on cycle normally points to air flow restriction.

Post the result.
Back to top
rlsundman  
#3 Posted : Friday, March 16, 2012 4:08:48 PM(UTC)
rlsundman

Rank: Member

Groups: Registered
Joined: 3/16/2012(UTC)
Posts: 3
Dryer vent is not blocked and have disconnected vent and run test in to open laundary room. Same results, Igniter glows, gas valve opens, have proper blue flame for 10 - 15 seconds then fire out. after about 1.5 minutes cycle starts again.
Back to top
Simon / APP Team  
#4 Posted : Saturday, March 17, 2012 8:31:47 AM(UTC)
Simon / APP Team

Rank: Advanced Member

Groups: APP Team
Joined: 2/12/2012(UTC)
Posts: 5,556
Hello.

First check the lint screen and the blower wheel housings for any restrictions.
Than put a jumper across the hi limit thermostat (see diagram#3 part#36).

Run it and post the results.

The thermostat Part number: AP2975888
Back to top
rlsundman  
#5 Posted : Saturday, March 17, 2012 11:27:49 AM(UTC)
rlsundman

Rank: Member

Groups: Registered
Joined: 3/16/2012(UTC)
Posts: 3
Jumper proved successful. Part ordered and should arrive for Tuesday.

Thanks for you professional help.
Back to top
Simon / APP Team  
#6 Posted : Saturday, March 17, 2012 2:37:37 PM(UTC)
Simon / APP Team

Rank: Advanced Member

Groups: APP Team
Joined: 2/12/2012(UTC)
Posts: 5,556
My pleasure. Good luck.
Back to top
Users browsing this topic
Guest (4)
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Privacy Policy | Powered by YAF.NET | YAF.NET © 2003-2024, Yet Another Forum.NET