Rank: Member
Groups: Registered
Joined: 12/1/2008(UTC) Posts: 1
|
I have a Roper drye that turns on and spins but has no heat. The heating element checks out visually and with ohm meter. I think it's a sensor but can't find troubleshooting info. Anyone have a guess on how to check sensors or another idea of what the problem could be?
Thanks much.
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 2/1/2008(UTC) Posts: 2,429
|
If you look on top of the heater housing, there is a thermal fuse. Take one of the wires off, and ohm it out. If that is good, then you need to check the power coming into the back of the dryer where the cord goes into. Just because the dryer runs, that does not mean that it has full power. Go outside, and flip the dryer breaker off and and on a few times. Tom ApplianceEducator.com
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close