Rank: Member
Groups: Registered
Joined: 7/24/2008(UTC)
Posts: 3
|
freezer, icemaker fine.
door acts like no power. no water, ice, or light.
already replaced spdt switch on frame.
my wiring diagram is incomplete.
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 5/28/2008(UTC)
Posts: 1,620
|
Take off the hinge cover at top of freezer door, and inspect the wiring, making sure the wires and connector looks good, you can disconnect it and squeez the female ends a bit to make sure you have good contact when you plug it back in. If that does not fix the problem, then you will be looking at replacing the board. Part Details - GE Control board, part number: WR55X129
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 7/24/2008(UTC)
Posts: 3
|
thanks badfish. man, that was fast! i already found the connector; looks ok. will give it a squeeze.
how do i get to that board?? it inside the door, right?
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 5/28/2008(UTC)
Posts: 1,620
|
Pop off the front cover that says ice, water etc. behind that are 4 screws, undo those and the whole assembly will slide out, you will need to disconnect the wire harness attached to the board to remove it all the way
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 5/28/2008(UTC)
Posts: 1,620
|
1 more thing I forgot, when you get the assy out, make sure the micro switch on the right side is being engaged when pressing for ice or water.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 7/24/2008(UTC)
Posts: 3
|
you da man, badfish.............thanks
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
