Washer will not drain completely, and has a banging noise when it does spins - Appliance Repair Forum

Welcome Guest! You can not login or register.

Notification

Error

Washer will not drain completely, and has a banging noise when it does spins Options Email this topic Watch this topic Print this topic » Normal Threaded
Model: LSQ9549PW3	Brand: Whirlpool	Age: 1 - 5 years
Previous Topic Next Topic

IVETTE		#1 Posted : Thursday, August 19, 2010 11:54:45 PM(UTC)
Rank: Member Groups: Registered Joined: 8/19/2010(UTC) Posts: 5		My washer fills and agitates the cloths but when it comes time for it to spin and drain it does not do that, at times. Again it does not happen all the time but the majority of the time it will. Ok, now when it does spin and drain it has this loud banging noise which will actually move the washer. I have also put only the front of my washer on some pieces of wood and it has helped alittle for the banging I mean you can still hear it but not as loud. The basket "I think is out of place" so it looks to be. I have to move the basket alittle back when I wash because if not it will not fill since the spout where the water comes out of does not reach. Could it be a spring, pump or both/neither? Any help would be greatly appreciated. It is a Whirlpool washer Model # LSQ9549PW3; Serial # CS2801742.


User Profile View All Posts by User View Thanks

Sponsor

See inside of your appliance - diagrams and part photos for virtually every model.

richappy		#2 Posted : Friday, August 20, 2010 1:22:35 AM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 9/10/2007(UTC) Posts: 9,586 Was thanked: 2 time(s) in 2 post(s)		I would pull off the outer cover and check for a disconnected spring in the back. For your spinning problems, go to my sticky above "replacing direct drive washer brakes shoes".


User Profile View All Posts by User View Thanks

IVETTE		#3 Posted : Friday, August 20, 2010 2:30:14 AM(UTC)
Rank: Member Groups: Registered Joined: 8/19/2010(UTC) Posts: 5		Would you happen to know which spring it would be?


User Profile View All Posts by User View Thanks

richappy		#4 Posted : Saturday, August 21, 2010 1:45:29 AM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 9/10/2007(UTC) Posts: 9,586 Was thanked: 2 time(s) in 2 post(s)		There is only one in the back, probably rusted off the frame.


User Profile View All Posts by User View Thanks

IVETTE		#5 Posted : Saturday, August 21, 2010 2:39:52 AM(UTC)
Rank: Member Groups: Registered Joined: 8/19/2010(UTC) Posts: 5		:) Thank You.


User Profile View All Posts by User View Thanks

Users browsing this topic
Guest (2)

Forum Jump

You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Important Information: The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies. More Details Close