Customer Support 7 days a week

Welcome Guest! You can not login or register.

Notification

Icon
Error

5 Pages«<345
Options
Go to last post Go to first unread
Gene  
#41 Posted : Friday, July 9, 2010 5:49:34 PM(UTC)
Gene

Rank: Advanced Member

Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455

Was thanked: 4 time(s) in 4 post(s)
If there is no broken or loose wire, then the optic boards are the first failure suspect.

- The PC board kit Part number: AP3137510
Part number: AP3137510



Gene.
wack70  
#42 Posted : Monday, August 9, 2010 8:10:28 AM(UTC)
wack70

Rank: Member

Groups: Registered
Joined: 7/6/2010(UTC)
Posts: 7

Gene, where would I look for a loose/broken wire? The wire harness coming out of the wall to the icemaker is about 6-8" long. Is it possible that it could be loose/broken somewhere in the wall that it goes into?

I am about to buy the optics kit, but wanted to check for this first.

Thanks.
Gene  
#43 Posted : Monday, August 9, 2010 6:20:33 PM(UTC)
Gene

Rank: Advanced Member

Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455

Was thanked: 4 time(s) in 4 post(s)
As it shown in the wiring diagram, you can check for 120 VAC between the BK/WH 4 and WH 8 at the receiver board.

If there is no proper voltage, then the boards are the culprit.

Gene.
wack70  
#44 Posted : Tuesday, August 10, 2010 4:59:16 PM(UTC)
wack70

Rank: Member

Groups: Registered
Joined: 7/6/2010(UTC)
Posts: 7

OK, it's definitely the board as you can see from the attached image... I pulled it out of the frame and there was a nickel-sized burn mark on the frame wall, along with a spot on the board that was charred as well (just above the screw).

What could have caused this?

I'll order the new kit and post the results asap.

Thanks!
wack70 attached the following image(s):
bad_board.jpg
Gene  
#45 Posted : Tuesday, August 10, 2010 5:09:02 PM(UTC)
Gene

Rank: Advanced Member

Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455

Was thanked: 4 time(s) in 4 post(s)
You are welcome. It's very hard to say what cause it. Mostly guessing.

Gene.
Users browsing this topic
Guest (9)
5 Pages«<345
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.