Is motor supposed to turn freely? - Appliance Repair Forum - Free Service from Appliance Parts Pros

Welcome Guest! You can not login or register.

Notification

Error

Is motor supposed to turn freely? Options Email this topic Watch this topic Print this topic » Normal Threaded
Model: S58NXMKE-6674	Brand: Whirlpool	Age: More than 10 years
Previous Topic Next Topic

ameyring		#1 Posted : Sunday, January 13, 2008 7:37:20 PM(UTC)
Rank: Member Groups: Registered Joined: 1/13/2008(UTC) Posts: 2		To try to understand motor movement to figure out why the dryer is noisy, I isolated the motor and it doesn't run, just hums when power is applied. With power disconnected, I can't turn the shaft. Is the shaft supposed to be loose enough to be turned with my fingers? Could humming also come from a defective electronic board? Thanks.


User Profile View All Posts by User View Thanks

Sponsor

See inside of your appliance - diagrams and part photos for virtually every model.

richappy		#2 Posted : Monday, January 14, 2008 2:55:39 AM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 9/10/2007(UTC) Posts: 9,586 Was thanked: 2 time(s) in 2 post(s)		Maybe you dropped a screw in the motor, it was running before! If ok, your motor bearings are bad. Motor shaft should turn and have no lateral play. If so, just order a new one.


User Profile View All Posts by User View Thanks

rsuch		#3 Posted : Monday, January 14, 2008 11:16:56 AM(UTC)
Rank: Member Groups: Registered Joined: 1/12/2008(UTC) Posts: 8		Yes, it should turn freely, especially if the belt is removed. It is apparently bound up, which would also cause a humming sound when applying power to it.


User Profile View All Posts by User View Thanks

ameyring		#4 Posted : Friday, January 18, 2008 9:15:08 PM(UTC)
Rank: Member Groups: Registered Joined: 1/13/2008(UTC) Posts: 2		Hi, Thanks for replying to my question. On a whim, I tested the motor while isolated and it seemed to run great. Perhaps something was stuck in there before or there was too much lint (I vacuumed the motor). Thus, I reinstalled the motor, testing it now and then with no problem. After dryer was put back together, motor returned to a humming state and eventually quit. After a few minutes, I could restart it, but then it would quit again. Is this the sign of a tired motor in need of replacement or could there be too much stress somewhere. Thanks!


User Profile View All Posts by User View Thanks

richappy		#5 Posted : Saturday, January 19, 2008 12:40:53 AM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 9/10/2007(UTC) Posts: 9,586 Was thanked: 2 time(s) in 2 post(s)		You have a bad motor, shaft should turn with almost no friction, like skating on wet ice.


User Profile View All Posts by User View Thanks

Users browsing this topic
Guest (4)

Forum Jump

You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Important Information: The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies. More Details Close