Customer Support 7 days a week

Welcome Guest! You can not login or register.

Notification

Icon
Error

Options
Go to last post Go to first unread
sofasurfer  
#1 Posted : Sunday, July 26, 2009 7:05:34 PM(UTC)
sofasurfer

Rank: Member

Groups: Registered
Joined: 7/26/2009(UTC)
Posts: 10

Kitchenaid washing machine KAWE850VAL1. It wasn't agitating or spinning. I could hear the motor run. I opened it up and found the coupler broken. I replaced the coupler and put everthing back together.

Now the motor is not running but I can hear it humming. I figure that what happened is that the transmission froze up and this is what caused the coupler to break. So I took it all apart again and sure enough, where the motor couples to the transmission, I am not able to turn the transmission shaft.

I decided I would put it back together until I can learn more about fixing it. I reattached the motor and pump and put the cabinet back into place. I thought, what the heck, I'll just try it one more time. I put it into the spin cycle and pulled the knob out. IT STARTED TO SPIN. I let it spin a few more seconds and it was spinning good. I shut it off and then pushed it back into postion against the wall. Then I put it back into the spin cycle and pulled the knob out. I WON"T SPIN AGAIN!!!! I can hear the motor humming. It does fill with water, although I only let a few cups of water to enter machine.

What do you think is going on? Is there shift linkage that could be screwed up. Cause it seems that I should be able to turn the transmission shaft by hand, but I do not know that for sure. What would cause it to not spin or agitate, then be ok when I messed with it, and then not spin again after I moved it?
Sponsor
See inside of your appliance - diagrams and part photos for virtually every model.

powered by AppliancePartsPros.com
 
sidfink43  
#2 Posted : Monday, July 27, 2009 3:51:24 PM(UTC)
sidfink43

Rank: Advanced Member

Groups: Senior Expert
Joined: 3/29/2009(UTC)
Posts: 11,699

Hi Sofasurfer

See if it will agitate and drain. If so, sounds like your brakes are hanging up in the spin cycle.

See the Stickey on brakes. If you go that route check the clutch also.

Good luck
Users browsing this topic
Guest (3)
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.