5 Pages123>» Go to Page...

Kenmore doesn't clean-"Clean " Flashning Seven times Options  Email this topic  Watch this topic  Print this topic » Normal Threaded
Model: 165-14200	Brand: Sears	Age: 1 - 5 years
Previous Topic Next Topic

demark		#1 Posted : Monday, December 24, 2007 9:43:06 AM(UTC)
Rank: Member Groups: Registered Joined: 12/24/2007(UTC) Posts: 1		I have a Kenmore dishwasher that appears to go through its cleaning cycle however there is soap residue left in dispenser and dishes are not clean. "Clean" light flashes 7 times--does that refer to a trouble code? Thanks-Merry Christmas !!
User Profile View All Posts by User View Thanks

Sponsor
	See inside of your appliance - diagrams and part photos for virtually every model. By Model Number By Part Description By Part Number powered by AppliancePartsPros.com

Gene		#2 Posted : Monday, December 24, 2007 10:10:25 AM(UTC)
Rank: Advanced Member Groups: Senior Expert, Administrators Joined: 7/19/2007(UTC) Posts: 27,455 Was thanked: 4 time(s) in 4 post(s)		The "Clean" light, flashing 7 times means a problem in the heating circuit. Reset the control as described in the tech's sheets (located in a pouch behind the bottom panel). If it'll happen again, check the heating element and the high limit thermostat. The model number you posted is incomplete. Happy Holidays! Gene.
User Profile View All Posts by User View Thanks

richappy		#3 Posted : Tuesday, December 25, 2007 12:51:04 AM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 9/10/2007(UTC) Posts: 9,586 Was thanked: 2 time(s) in 2 post(s)		Your hot water may be too cold, just increase temperature. Open door, within 3 seconds hit high temp. scrub,energy saver dry, then repeat (if no such buttons press similar ones} Close door and press cancel. Good luck,Merry Christmas.
User Profile View All Posts by User View Thanks

Neal		#4 Posted : Thursday, December 27, 2007 1:17:50 PM(UTC)
Rank: Member Groups: Registered Joined: 12/27/2007(UTC) Posts: 21		I have the same problem with my Kenmore. How do you reset the dishwasher as stated in the early post. There's nothing in my tech sheet. Thanks.
User Profile View All Posts by User View Thanks

richappy		#5 Posted : Thursday, December 27, 2007 1:47:43 PM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 9/10/2007(UTC) Posts: 9,586 Was thanked: 2 time(s) in 2 post(s)		Just follow the directions for Demark above
User Profile View All Posts by User View Thanks

Neal		#6 Posted : Friday, December 28, 2007 1:52:02 AM(UTC)
Rank: Member Groups: Registered Joined: 12/27/2007(UTC) Posts: 21		I was able to reset the flashing green light. There was no error code shown afterwards. Then I ran the normal wash cycle. Took a few minutes to start. On the screen started at 55, went down to 48 (?) then dropped to 2. Finished out the cycle. Afterwards the flashing green light. I could do the sequence all over again. Neal
User Profile View All Posts by User View Thanks

richappy		#7 Posted : Friday, December 28, 2007 3:28:20 AM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 9/10/2007(UTC) Posts: 9,586 Was thanked: 2 time(s) in 2 post(s)		Check your service sheet. The dishwasher is sensing a bad heater. Check the heater and heater thermostat.
User Profile View All Posts by User View Thanks

Neal		#8 Posted : Friday, December 28, 2007 3:53:02 AM(UTC)
Rank: Member Groups: Registered Joined: 12/27/2007(UTC) Posts: 21		I'm at work right now, How do I check those items? I'll check them later this evning. Thanks for your help.
User Profile View All Posts by User View Thanks

richappy		#9 Posted : Friday, December 28, 2007 5:02:50 AM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 9/10/2007(UTC) Posts: 9,586 Was thanked: 2 time(s) in 2 post(s)		Crunch your model # in this site to get assembly info.
User Profile View All Posts by User View Thanks

Neal		#10 Posted : Friday, December 28, 2007 4:05:21 PM(UTC)
Rank: Member Groups: Registered Joined: 12/27/2007(UTC) Posts: 21		Richappy, Where on this site do you find that info? First time user, Sorry. Thanks
User Profile View All Posts by User View Thanks

Users browsing this topic

Guest (7)

5 Pages123>» Go to Page...